Congratulations, you’ve
gone wireless!
TM
Getting Started
Step 1
Step 2
Step 3
Wireless Adapter
Quick Start Guide
The Ooma Telo Wireless Adapter enables your Ooma Telo®
to connect to the Internet wirelessly over your Wi-Fi network.
This means you’ll have the flexibility to install your Telo
anywhere in your home where you have access to Wi-Fi.
You may now disconnect the hardwired Ethernet cable
connecting your Ooma Telo to your modem or router.
You’re free to move your Telo to a more central location
in your home!
Take a moment to think about a convenient place to put your
Ooma Telo and home phone. It should be centrally located
since you will use the Telo to check voicemail and access
enhanced features like Call Screening and Do Not Disturb.
Next time you power up the Ooma Telo, it will connect to
the Internet wirelessly through your home Wi-Fi network.
As before, the Telo will be ready for use when the Ooma
logo stops flashing red and all the buttons turn blue. Pick
up the phone connected to your Telo and listen for the
musical Ooma dialtone to confirm that you are ready to
make and receive calls.
Setting up the Wireless Adapter will take about 10 minutes.
You’ll need access to:
• A desktop or laptop computer with an Ethernet port
If your Ooma Telo is not able to connect wirelessly, see the
Troubleshooting section on the back for corrective actions
you can try. Keep in mind that a hardwired Ethernet cable
(plugged into the TO INTERNET port) will override use of
the Wireless Adapter.
• An Ethernet cable
Install the Wireless Adapter
Configure wireless settings
On the computer you connected to the Telo, open up a
Connect a computer to your Telo
Use your Ethernet cable to connect a computer to the
IMPORTANT: Before you begin, verify that your
Ooma Telo is fully functional. If your Telo has not
been installed yet, we recommend that you follow the
bundled instructions to first set it up with a hardwired
Ethernet connection. This will ensure that your Telo is
operational and has downloaded the latest software
to support the Wireless Adapter.
Make sure the adapter is properly aligned with the USB
port on the back of your Ooma Telo and plug it in. Press
firmly to ensure the adapter is inserted all the way in,
but do not use excessive force. Rotate it upward for
optimal reception.
Web browser and navigate to:
HOME NETWORK port of the Ooma Telo.
IMPORTANT: If your Ooma Telo was set up in
between your modem and router prior to installing
the Wireless Adapter, be sure to reconnect the WAN
(or Internet) port of the router to your modem and
then power cycle both devices.
Click on the Wireless tab and follow the directions on the
screen to link the Telo to your home Wi-Fi network.
Note: You’ll need to know the name and password for
your home wireless network.
Step 2
Step 3
Go to
Go to
Step 1
Go to
700-0117-102
|